Tip on easier release of HP pins
About admin
Related Posts
06/04/2020
(700grs “Grand Canyon” HP/FP)1) Clean this mold completely before use to remove machining oils, which will otherwise cause wrinkles when the oils burn off.2) I would run the mold halves through at least two.
04/06/2019
Powder coating lead bullets – dry tumble (DT) method This is the method I now use to powder-coat (PC) pistol and rifle cast bullets. I use this method, because it worked so well from the.
04/06/2019
MP MOLDS and me I began casting with brass moulds when I got my first HP mould, made by MP Moulds, work of Miha Prevec. Before that, I was using traditional iron moulds with ladle/pot.
03/06/2019
Check out this cool video about our molds and the dedication to perfection. See how the assembly of our molds works!https://www.youtube.com/watch?time_continue=2&v=zgzvV2fjyho
03/06/2019
Assembly, cleaning, prepping, lubing
I start by cleaning the mould with brake cleaner, including the pins and the screws that hold the pins in. You can clean your new mould with warm water first but.