(700grs “Grand Canyon” HP/FP)1) Clean this mold completely before use to remove machining oils, which will otherwise cause wrinkles when the oils burn off.2) I would run the mold halves through at least two.

Powder coating lead bullets – dry tumble (DT) method This is the method I now use to powder-coat (PC) pistol and rifle cast bullets. I use this method, because it worked so well from the.

MP MOLDS and me I began casting with brass moulds when I got my first HP mould, made by MP Moulds, work of Miha Prevec. Before that, I was using traditional iron moulds with ladle/pot.

For easier release of hollow point pins, you can use soft graphite pencil and simply "paint" the part of the HP pin. (in contact with lead). 

Assembly, cleaning, prepping, lubing I start by cleaning the mould with brake cleaner, including the pins and the screws that hold the pins in. You can clean your new mould with warm water first but.