Additional information
| Caliber (As cast) | .357 |
|---|---|
| Dodatni_Opis | Brass mold for hobby hand casting (set contains mold, allen keys, metal pin) |
| Handles included? | No |
| Material | Brass |
| Number of cavities | 2 cavites |
| Pb-Bb-Gc-Hb | Plain base |
MP 357-125 HP PB 2 cavity mold
MP 357-125 HP PB 2 cavity mold
€ 65.00
- Cast .357 cal. bullets – 125 Hollow point or 130 grain solid
- Round, penta and blank pins
- 2 cavity mold
- For use in 9 mm, too. Easily sizes down to .356 diameter
- Steel sprue plate
- Hardened steel alignment pins
- Allen keys included
- RCBS/Lyman top punch included
- Use LEE 6 cavity handle or MP mold handles (NOT included)
See our product pictures in gallery
7 in stock
Description
- Cast .357 cal. bullets – 125 Hollow point or 130 grain solid
- Round, penta and blank pins
- 2 cavity mold
- For use in 9 mm, too. Easily sizes down to .356 diameter
- Steel sprue plate
- Hardened steel alignment pins
- Allen keys included
- RCBS/Lyman top punch included
- Use LEE 6 cavity handle or MP mold handles (NOT included)
See our product pictures in gallery
Michael (verified owner) –
Cleaned it. Heat cycled it. Still having issues with side surface on 1 of 2 cavities. Will keep working with it. Using 2Sn-5Sb. I know it takes a little break-in. Only 2 suggestions and one question. 1) the sprue stop pin being hollow, let’s a misfill run in and causes hangup that interrupts the cadence, and 2) lock washer on sprue mounting screw has 2 contact points to plate which I believe can cause potential cutting alignment, so I have added a thin flat washer underneath it. ?) Seems like the HP pin material does not heat up very well. Is it steel? Think I could run a little cooler if not for the pin.
The overall design is awesome !!!!!!!
Just not getting my yield yet.