(700grs “Grand Canyon” HP/FP)1) Clean this mold completely before use to remove machining oils, which will otherwise cause wrinkles when the oils burn off.2) I would run the mold halves through at least two.

Powder coating lead bullets – dry tumble (DT) method This is the method I now use to powder-coat (PC) pistol and rifle cast bullets. I use this method, because it worked so well from the.

MP MOLDS and me I began casting with brass moulds when I got my first HP mould, made by MP Moulds, work of Miha Prevec. Before that, I was using traditional iron moulds with ladle/pot.

Check out this cool video about our molds and the dedication to perfection. See how the assembly of our molds works!https://www.youtube.com/watch?time_continue=2&v=zgzvV2fjyho

For easier release of hollow point pins, you can use soft graphite pencil and simply "paint" the part of the HP pin. (in contact with lead). 

Assembly, cleaning, prepping, lubing I start by cleaning the mould with brake cleaner, including the pins and the screws that hold the pins in. You can clean your new mould with warm water first but.