Welcome, post so we know your here…

[Anonymous]

Lets start generating ideas and open up the conversations.

Say hello and where you are from on this thread.
The state a bullet type you are looking for.

[adminKeymaster]

Cool…. It’s aliveeee

I will improve this forum as we go, so any ideas are more than welcome.

[Alex13Participant]

I polished the lower part of the sprue plate and the upper part of the mold block.

Now I think, but have I done worse? Lee makes ventilation grooves on the top of the mold block, can my sliding gate plate degrade performance?

[Anonymous]

Bill Arrington here. From USA. West Virginia.

I missed the sign-up on cast boolits forum for your 44 magnum hp mold.
If you make a few extra I’d like to get a 2 or 4 banger brass gas check hp with
all the pins. Thanks.

[JosephParticipant]

Joseph “Littlewolf” Wedel

Kansas, USA

recently purchased the 9mm-147 RCBS 556 clone in 8cavity cast over 40LB of keeper boolits in about 2 hours, wish i could get a 4cavity hollow point of the same design

[Griz44magParticipant]

I am a big fan of Mihec’s molds, have been using several of these since before this fancy website was concieved.

Now I am back because I heard there were round ball molds now.

Gotta get some of this!

 

[Author]

Posts